D-Link DSR-500 - Page 168

Unified Services Router User Manual
166
Created EAP/PEAP context: OK
DEBUG
Setting message in fragment buffer:
ERROR
ERROR
Deleted EAP/PEAP context: OK
DEBUG
Allocating TLS read buffer is NULL:
ERROR
ERROR
Upper EAP sent us: decision = %d
method state = %d
DEBUG
Setting last fragment: ERROR
ERROR
P2 decision=(%d); methodState=(%d)
DEBUG
Getting message: ERROR
ERROR
Writing message to BIO: ERROR.
DEBUG
Processing PEAP message: ERROR
ERROR
Encrypted (%d) bytes for P2
DEBUG
Setting fragment: ERROR
ERROR
P2: sending fragment.
DEBUG
Creating receive buffer: ERROR
ERROR
P2: message size = %d
DEBUG
Setting first fragment: ERROR
ERROR
P2: sending unfragmented message.
DEBUG
Sending P1 response: ERROR
ERROR
P1: Sending fragment.
DEBUG
NULL request (or response) PDU or
NULL context: ERROR
ERROR
P1: Total TLS message size = (%d)
DEBUG
Expecting start packet, got something
else: ERROR
ERROR
P1: sending unfragmented message.
DEBUG
Protocol version mismatch: ERROR
ERROR
peapFragFirstProcess: TLS record size
to receive = (%d)
DEBUG
Processing PEAP message (from
frag): ERROR
ERROR
Setting version %d
DEBUG
Processing PEAP message: ERROR
ERROR
PEAP pkt rcvd: data len=(%d) flags=(%d)
version=(%d)
DEBUG
Processing PEAP message: ERROR
ERROR
Got PEAP/Start packet.
DEBUG
Indicated length not valid: ERROR
ERROR
Got first fragment
DEBUG
Did not get Acknowledged result:
ERROR
ERROR
Got fragment (n)
DEBUG
Cannot understand AVP value:
ERROR
ERROR
Got last fragment
DEBUG
eapExtResp is NULL: ERROR
ERROR
Got unfragmented message
DEBUG
eapWscCtxCreate:
EAPAUTH_MALLOC failed.
ERROR
Got frag ack.
DEBUG
eapWscProcess: umiIoctl req to WSC
failed, status = %d
ERROR
Ext AVP parsed: flags=(0x%x)
DEBUG
eapWscCheck: Invalid frame
ERROR
Mandatory bit not set: WARNING
DEBUG
eapWscBuildReq: Invalid state %d
ERROR
Ext AVP parsed: type=(%d)
DEBUG
eapWscProcessWscResp: Invalid data
recd pData = %p, dataLen"
ERROR
Ext AVP parsed: value=(%d)
DEBUG
Data received for invalid context,
dropping it
ERROR
Got PEAPv0 success!
DEBUG
eapWscProcessWscResp: Build
Request failed
ERROR
Got PEAPv0 failure!
DEBUG
eapWscProcessWscResp: Invalid
state %d
ERROR
pCtx NULL.
DEBUG
eapWscProcessWscResp: Message
processing failed 0x%X
ERROR
Authenticator response check: Error
DEBUG
eapWscProcessWscData: Invalid
notification recd %d
ERROR
Authenticator response check: Failed
DEBUG
unable to initialize MD5
ERROR
MS-CHAP2 Response AVP size = %u
DEBUG
MDString: adpDigestInit for md5 failed
ERROR
Created EAP/MS-CHAP2 context: OK.
DEBUG
EAPAUTH_MALLOC failed.
ERROR
pCtx NULL.
DEBUG
EAPAUTH_MALLOC failed.
ERROR
Deleted EAP/MS-CHAPv2 context: OK
DEBUG
NULL context created: Error
ERROR
Not authenticated yet.
DEBUG
NULL context received: Error
ERROR
Authenticator response invalid
DEBUG
Authenticator ident invalid.
ERROR
EAP-MS-CHAPv2 password changed.
DEBUG
Success request message invalid:
ERROR