8D-Link DUB-1312 User Manual
Section 2 - Installation
After you insert the CD into the CD drive, the DUB-1312 menu screen
will appear. Click Install to begin the DUB-1312 driver installation. The
InstallShield Wizard window will pop up.
This driver does not have WHQL digitally signed certication. If you see a
warning message, you must accept the unsigned driver installation in order
to continue. Windows XP x64 users should disable WHQL checking in order
to install the driver.
Note: The DUB-1312 user interface may dier in appearance for dierent regions.
Windows® XP
Plug the DUB-1312’s USB cable into an available USB port on your PC. Within
a few seconds, Windows will detect a new device. You will see the Found New
Hardware message in the pop-up window.
To Next Page
Loading...
