D-Link DWR-M961 - 5.3.5 Route; 5.3.5.1 Default Route; 5.3.5.2 Static Route

User Manual of DWR-M961
-66-
5.3.5 Route
This menu shows you the current default route and static route. Static Route reduces route selection problems
and corresponding data overload and accelerates data packet forwarding.
5.3.5.1. Default Route
You can select which wan connection as default gateway route.if not ,system will auto select a connect up wan
as default gateway route.
Figure 5-3-9 Default Route
5.3.5.2. Static Route
Figure 5-3-10 Static Route
Object Description
Enable Static Route
Enable or disable Static route.
IP Address
Enter the destination network
Subnet Mask
Enter the network mask
Gateway
Enter the network gateway
URL Address
Block or allow access URL.