12D-Link DCS-910/920 User Manual
Section 2 - Installation
Turn on the computer and Insert the D-Link DCS-910/920 Driver CD in the CD-ROM drive. The following step-by-step
instructions will be shown in Windows
®
XP. The similar steps and screens will be shown for other Windows operating
systems.
If the CD Autorun function does not automatically start on your computer, click Windows Start > Run. In the Run
command box type “D:\DCS910920.exe”, where D: represents the drive letter of your CD-ROM. If it does start, proceed
to the next screen.
Software Installation
Click Setup Wizard
To Next Page