EasyManuals Logo

D-Link xStack DES-3526 User Manual

D-Link xStack DES-3526
222 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #102 background imageLoading...
Page #102 background image
DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
99
DES-3526:4#config vlan v1 delete 6-8
Command: config vlan v1 delete 6-8
Success.
DES-3526:4#
config gvrp
Purpose Used to configure GVRP on the Switch.
Syntax
config gvrp [<portlist> | all] {state [enable | disable] |
ingress_checking [enable | disable] | acceptable_frame
[tagged_only | admit_all] | pvid <vlanid 1-4094>}
Description This command is used to configure the Group VLAN Registration
Protocol on the Switch. Ingress checking, the sending and receiving
of GVRP information, and the Port VLAN ID (PVID) can be
configured.
Parameters
<portlist> A port or range of ports for which you want to enable
GVRP for.
all Specifies all of the ports on the Switch.
state [enable | disable] Enables or disables GVRP for the ports
specified in the port list.
ingress_checking [enable | disable] Enables or disables ingress
checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter states
the frame type that will be accepted by the Switch for this function.
tagged_only implies that only VLAN tagged frames will be accepted,
while admit_all implies tagged and untagged frames will be accepted
by the Switch.
pvid <vlanid 1-4094> – Specifies the default VLAN associated with
the port.
Restrictions Only administrator-level users can issue this command.
Example usage:
To set the ingress checking status, the sending and receiving GVRP information :
DES-3526:4#config gvrp 1-4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Command: config gvrp 1-4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Success.
DES-3526:4#
enable gvrp
Purpose Used to enable GVRP on the Switch.
Syntax
enable gvrp
Description This command, along with disable gvrp below, is used to enable and
disable GVRP on the Switch, without changing the GVRP configuration
on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link xStack DES-3526 and is the answer not in the manual?

D-Link xStack DES-3526 Specifications

General IconGeneral
BrandD-Link
ModelxStack DES-3526
CategorySwitch
LanguageEnglish

Related product manuals