DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
110
config address_binding ip_mac ipaddress
Purpose Used to Configure a IP-MAC Binding entry.
Syntax
<ipaddr> mac_address <macaddr> {ports [<portlist> | all]}
Description This command will configure an IP-MAC Binding entry.
Parameters <ipaddr> - The IP address of the device where the IP-MAC binding is
made.
<macaddr> - The MAC address of the device where the IP-MAC binding
is made.
<portlist> - Specifies a port or range of ports to be configured for address
binding.
all – Specifies that all ports on the switch will be configured for address
binding.
Restrictions Only administrator-level users can issue this command.
Example usage:
To config address binding on the switch:
DES-3526:4#config address_binding ip_mac ipaddress
10.1.1.3 mac_address 00-00-00-00-00-05
Command: config address_binding ip_mac ipaddress
10.1.1.3 mac_address 00-00-00-00-00-05
Success.
DES-3526:4#
config address_binding ip_mac ports
Purpose Used to configure an IP-MAC state to enable or disable for specified
ports.
Syntax
[<portlist> | all] state [enable | disable]
Description This command will configure IP-MAC state to enable or disable for
specified ports.
Parameters
<portlist> − Specifies a port or range of ports.
all – specifies all ports on the switch.
state [enable | disable] – Enables or disables the specified range of ports.
Restrictions Only administrator-level users can issue this command.
Example usage:
To config address binding on the switch:
DES-3526:4#config address_binding ip_mac ports 2 state
enable
Command: config address_binding ip_mac ports 2 state
enable
Success.
DES-3526:4#
To Next Page
Loading...
