DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
140
config 802.1x auth_parameter
Request/Identity packets.
server_timeout <sec 1-65535> - Configure the length of time to wait
for a response from a RADIUS server.
max_req <value 1-10> − Configures the number of times to retry
sending packets to a supplicant (user).
reauth_period <sec 1-65535> − Configures the time interval between
successive re-authentications.
enable_reauth [enable | disable] − Determines whether or not the
Switch will re-authenticate. Enabled causes re-authentication of
users at the time interval specified in the Re-authentication Period
field, above.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20:
DES-3526:4#config 802.1x auth_parameter ports 1–20 direction both
Command: config 802.1x auth_parameter ports 1–20 direction both
Success.
DES-3526:4#
config 802.1x auth_protocol
Purpose Used to configure the 802.1x authentication protocol on the Switch.
Syntax
config 802.1x auth_protocol [radius_eap | radius_pap]
Description The config 802.1x auth_protocol command enables you to configure
the authentication protocol.
Parameters radius_eap | radius_pap – Specify the type of authentication protocol
desired.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the authentication protocol on the Switch:
DES-3526:4# config 802.1x auth_protocol radius_pap
Command: config 802.1x auth_protocol local radius_pap
Success.
DES-3526:4#
config 802.1x init
Purpose Used to initialize the 802.1x function on a range of ports.
Syntax
config 802.1x init {port_based ports [<portlist> | all] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr>}]
Description The config 802.1x init command is used to immediately initialize the
802.1x functions on a specified range of ports or for specified MAC
addresses operating from a specified range of ports.
Parameters port_based – This instructs the Switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization can
To Next Page
Loading...
