DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
139
config 802.1x capability ports
all − Specifies all of the ports on the Switch.
authenticator − A user must pass the authentication process to gain
access to the network.
none − The port is not controlled by the 802.1x functions.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x capability on ports 1-10:
DES-3526:4#config 802.1x capability ports 1 – 10 authenticator
Command: config 802.1x capability ports 1 – 10 authenticator
Success.
DES-3526:4#
config 802.1x auth_parameter
Purpose
Used to configure the 802.1x Authentication parameters on a range
of ports. The default parameter will return all ports in the specified
range to their default 802.1x settings.
Syntax config 802.1x auth_parameter ports [<portlist> | all] [default |
{direction [both | in] | port_control [force_unauth | auto |
force_auth] | quiet_period <sec 0-65535> | tx_period <sec 1-
65535> | supp_timeout <sec 1-65535> | server_timeout <sec 1-
65535> | max_req <value 1-10> | reauth_period <sec 1-65535> |
enable_reauth [enable | disable]}]
Description
The config 802.1x auth_parameter command is used to configure
the 802.1x Authentication parameters on a range of ports. The
default parameter will return all ports in the specified range to their
default 802.1x settings.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
all − Specifies all of the ports on the Switch.
default − Returns all of the ports in the specified range to their
802.1x default settings.
direction [both | in] − Determines whether a controlled port blocks
communication in both the receiving and transmitting directions, or
just the receiving direction.
port_control − Configures the administrative control over the
authentication process for the range of ports. The user has the
following authentication options:
• force_auth − Forces the Authenticator for the port to
become authorized. Network access is allowed.
• auto
−
Allows the port’s status to reflect the outcome of the
authentication process.
• force_unauth − Forces the Authenticator for the port to
become unauthorized. Network access will be blocked.
quiet_period <sec 0-65535> − Configures the time interval between
authentication failure and the start of a new authentication attempt.
tx_period <sec 1-65535> - Configures the time to wait for a response
from a supplicant (user) to send EAP Request/Identity packets.
supp_timeout <sec 1-65535> - Configures the time to wait for a
response from a supplicant (user) for all EAP packets, except for the
To Next Page
Loading...
Need help?
General