D-Link xStack DGS-3450 - Link Aggregation Commands

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
16
LINK AGGREGATION COMMANDS
The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create link_aggregation
group_id
<value 1-32> {type [lacp | static]}
delete link_aggregation
group_id
<value 1-32>
config link_aggregation
group_id
<value1-32> {master_port <port> | ports <portlist> state [enable
| disable]}
config link_aggregation
algorithm
[mac_source | mac_destination | mac_source_dest | ip_source
| ip_destination | ip_source_dest]
show link_aggregation {group_id <value 1-32> | algorithm}
config lacp_port <portlist> mode [active | passive]
show lacp_port {<portlist>}
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose Used to create a link aggregation group on the Switch.
Syntax
create link_aggregation group_id <value 1-32> {type[lacp | static]}
Description This command will create a link aggregation group with a unique
identifier.
Parameters
<value> − Specifies the group ID. The Switch allows up to 32 link
aggregation groups to be configured. The group number identifies each
of the groups.
type – Specify the type of link aggregation used for the group. If the type
is not specified the default type is static.
Restrictions Only administrator-level users can issue this command.
lacp – This designates the port group as LACP compliant.
LACP allows dynamic adjustment to the aggregated port group.
LACP compliant ports may be further configured (see config
lacp_ports). LACP compliant must be connected to LACP
compliant devices.
•
• static – This designates the aggregated port group as static.
Static port groups can not be changed as easily as LACP
compliant port groups since both linked devices must be
manually configured if the configuration of the trunked group is
changed. If static link aggregation is used, be sure that both
ends of the connection are properly configured and that all ports
have the same speed/duplex settings.
Example usage:
To create a link aggregation group:
109