EasyManuals Logo

D-Link xStack DGS-3450 User Manual

D-Link xStack DGS-3450
247 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #121 background imageLoading...
Page #121 background image
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
18
BASIC IP COMMANDS
The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config ipif <ipif_name 12> [{ipaddress <network_address> |
vlan <vlan_name 32> | state [enable | disable]} bootp | dhcp]
show ipif {<ipif_name 12>}
enable autoconfig*
Each command is listed, in detail, in the following sections.
*See Switch Utility Commands for descriptions of all autoconfig commands.
config ipif
Purpose Used to configure the System IP interface.
Syntax
config ipif <ipif_name 12> [{ipaddress <network_address> [vlan
<vlan_name 32> | state [enable | disable]} | bootp | dhcp]
This command is used to configure the System IP interface on the
Switch.
Parameters <ipif_name 12> - Enter an alphanumeric string of up to 12 characters
to identify this IP interface.
ipaddress <network_address> IP address and netmask of the IP
interface to be created. You can specify the address and mask
information using the traditional format (for example,
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
<vlan_name 32> The name of the VLAN corresponding to the
System IP interface.
state [enable | disable] Allows you to enable or disable the IP
interface.
bootp Allows the selection of the BOOTP protocol for the
assignment of an IP address to the Switch’s System IP interface.
dhcp Allows the selection of the DHCP protocol for the assignment
of an IP address to the Switch’s System IP interface. If you are using
the autoconfig feature, the Switch becomes a DHCP client
automatically so it is not necessary to change the ipif settings.
Restrictions Only administrator-level users can issue this command.
Description
Example usage:
To configure the IP interface System:
DGS-3400:4#config ipif System ipaddress 10.48.74.122/8
Command: config ipif System ipaddress 10.48.74.122/8
Success.
DGS-3400:4#
118

Other manuals for D-Link xStack DGS-3450

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link xStack DGS-3450 and is the answer not in the manual?

D-Link xStack DGS-3450 Specifications

General IconGeneral
BrandD-Link
ModelxStack DGS-3450
CategorySwitch
LanguageEnglish

Related product manuals