D-Link xStack DGS-3450 - Command History List

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
35
COMMAND HISTORY LIST
?
The switch history commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config
command_history
<value 1-40>
show
command_history
Each command is listed, in detail, in the following sections.
?
Purpose Used to display all commands in the Command Line Interface
(CLI).
? {<command>}
Syntax
Description This command will display all of the commands available
through the Command Line Interface (CLI).
Parameters {<command>} – Entering the question mark with an appropriate
command will list all the corresponding parameters for the
specified command, along with a brief description of the
commands function and similar commands having the same
words in the command.
Restrictions None.
Example usage:
To display all of the commands in the CLI:
DGS-3400:4#?
..
?
clear
clear arptable
clear counters
clear fdb
clear log
clear port_security_entry port
config 802.1p default_priority
config 802.1p user_priority
config 802.1x auth_mode
config 802.1x auth_parameter ports
config 802.1x auth_protocol
config 802.1x capability ports
config 802.1x init
config 802.1x reauth
config access_profile profile_id
config account
config admin local_enable
config arpentry
config authen application
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
config arp_aging time
237