xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
4
BASIC SWITCH COMMANDS
The basic switch commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create account [admin | user] <username 15>
config account <username>
show account
delete account <username>
show module_info
show device_status
show session
show switch
show serial_port
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] auto_logout [never | 2_minutes | 5_minutes
| 10_minutes | 15_minutes]}
enable clipaging
disable clipaging
enable telnet <tcp_port_number 1-65535>
disable telnet
enable web <tcp_port_number 1-65535>
disable web
save {[config <config_id 1-2> | log | all]}
reboot
reset {[config | system]}
login
logout
Each command is listed, in detail, in the following sections.
create account
Purpose
Used to create user accounts.
Syntax create [admin | user] <username 15>
Description
The create account command is used to create user accounts that
consist of a username of 1 to 15 characters and a password of 0 to
15 characters. Up to 8 user accounts can be created.
Parameters admin <username 15>
user <username 15>
Restrictions
Only Administrator-level users can issue this command.
Usernames can be between 1 and 15 characters.
Passwords can be between 0 and 15 characters.
10
To Next Page
Loading...
