EasyManua.ls Logo

D-Link xStack DGS-3450 - Page 114

D-Link xStack DGS-3450
247 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#config link_aggregation group_id 1 master_port 5 ports 5-7, 9
Command: config link_aggregation group_id 1 master_port 5 ports 5-7, 9
Success.
DGS-3400:4#
config link_aggregation algorithm
Purpose Used to configure the link aggregation algorithm.
Syntax
config link_aggregation algorithm [mac_source | mac_destination |
mac_source_dest | ip_source | ip_destination | ip_source_dest]
Description This command configures the part of the packet examined by the Switch
when selecting the egress port for transmitting load-sharing data. This
feature is only available using the address-based load-sharing algorithm.
Parameters
mac_source Indicates that the Switch should examine the MAC source
address.
mac_destination Indicates that the Switch should examine the MAC
destination address.
mac_source_dest Indicates that the Switch should examine the MAC
source and destination addresses
ip_source Indicates that the Switch should examine the IP source
address.
ip_destination Indicates that the Switch should examine the IP destination
address.
ip_source_dest Indicates that the Switch should examine the IP source
address and the destination address.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure link aggregation algorithm for mac-source-dest:
DGS-3400:4#config link_aggregation algorithm mac_source_dest
Command: config link_aggregation algorithm mac_source_dest
Success.
DGS-3400:4#
show link_aggregation
Purpose Used to display the current link aggregation configuration on the
Switch.
Syntax
show link_aggregation {group_id <value 1-32> | algorithm}
Description This command will display the current link aggregation configuration
of the Switch.
Parameters
<value 1-32> Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number
identifies each of the groups.
algorithm Allows you to specify the display of link aggregation by
the algorithm in use by that group.
Restrictions None.
111

Other manuals for D-Link xStack DGS-3450

Related product manuals