xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show lacp_port
Purpose Used to display current LACP port mode settings.
Syntax
show
lacp_port {<portlist>}
Description This command will display the LACP mode settings as they are
currently configured.
Parameters <portlist> - Specifies a port or range of ports to be configured.
If no parameter is specified, the system will display the current LACP
status for all ports.
Restrictions None.
Example usage:
To display LACP port mode settings:
DGS-3400:4#show lacp_port 1-10
Command: show lacp_port 1-10
Port Activity
------ --------
1 Active
2 Active
3 Active
4 Active
5 Active
6 Active
7 Active
8 Active
9 Active
10 Active
DGS-3400:4#
113
To Next Page
Loading...
