xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#show 802.1x auth_state
Command: show 802.1x auth_state
Index MAC Address Auth PAE State Backend State Port Status
4
7
10
Port number : 1
------ ------------------- ----------------------- --------------------- -----------------
1 00-08-02-4E-DA-FA Authenticated Idle Authorized
2
3
5
6
8
9
11
12
13
14
15
16
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
config 802.1x auth_mode
Used to configure the 802.1x authentication mode on the Switch.
config 802.1x auth_mode {port_based | mac_based]
Description The config 802.1x authentication mode command is used to enable either
the port-based or MAC-based 802.1x authentication feature on the Switch.
Parameters
[port_based | mac_based] − The Switch allows you to authenticate 802.1x by
either port or MAC address.
Restrictions Only administrator-level users can issue this command.
Purpose
Syntax
Example usage:
To configure 802.1x authentication by MAC address:
DGS-3400:4#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DGS-3400:4#
config 802.1x capability ports
Purpose Used to configure the 802.1x capability of a range of ports on the
Switch.
Syntax
config 802.1x capability ports [<portlist> | all] [authenticator |
none]
Description The config 802.1x command has four capabilities that can be set for
each port. Authenticator, Supplicant, Authenticator and Supplicant,
and None.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
140
To Next Page
Loading...
