xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Example usage:
To configure the RADIUS server communication settings:
DGS-3400:4#config radius add 1 10.48.74.121 key dlink default
Command: config radius add 1 10.48.74.121 key dlink default
Success.
DGS-3400:4#
config radius delete
Purpose Used to delete a previously entered RADIUS server configuration.
Syntax
config radius delete <server_index 1-3>
Description The config radius delete command is used to delete a previously
entered RADIUS server configuration.
Parameters
<server_index 1-3> − Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server settings
can be entered on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete previously configured RADIUS server communication settings:
DGS-3400:4#config radius delete 1
Command: config radius delete 1
Success.
DGS-3400:4#
config radius
Purpose Used to configure the Switch’s RADIUS settings.
Syntax
config radius <server_index 1-3> {ipaddress <server_ip> | key
<passwd 32> | auth_port <udp_port_number 1-65535> |
acct_port <udp_port_number 1-65535>}
Description The config radius command is used to configure the Switch’s
RADIUS settings.
Parameters
<server_index 1-3> − Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server settings
can be entered on the Switch.
ipaddress <server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used
between the Switch and the RADIUS server.
auth_port <udp_port_number 1-65535> − The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> − The UDP port number for
accounting requests. The default is 1813.
Restrictions Only administrator-level users can issue this command.
<passwd 32> − The shared-secret key used by the
RADIUS server and the Switch. Up to 32 characters can
be used.
•
144
To Next Page
Loading...
