D-Link xStack DGS-3450 - Page 183

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#show arpentry
Command: show arpentry
System 10.1.1.254 00-01-30-FA-5F-00 Dynamic
ARP Aging Time : 30
Interface IP Address MAC Address Type
------------- --------------- ----------------- ---------------
System 10.0.0.0 FF-FF-FF-FF-FF-FF Local/Broadcast
System 10.1.1.169 00-50-BA-70-E4-4E Dynamic
System 10.9.68.1 00-A0-C9-A4-22-5B Dynamic
System 10.9.68.4 00-80-C8-2E-C7-45 Dynamic
System 10.10.27.51 00-80-C8-48-DF-AB Dynamic
System 10.11.22.145 00-80-C8-93-05-6B Dynamic
System 10.11.94.10 00-10-83-F9-37-6E Dynamic
System 10.14.82.24 00-50-BA-90-37-10 Dynamic
System 10.15.1.60 00-80-C8-17-42-55 Dynamic
System 10.17.42.153 00-80-C8-4D-4E-0A Dynamic
System 10.19.72.100 00-50-BA-38-7D-5E Dynamic
System 10.21.32.203 00-80-C8-40-C1-06 Dynamic
System 10.40.44.60 00-50-BA-6B-2A-1E Dynamic
System 10.42.73.221 00-01-02-03-04-00 Dynamic
System 10.44.67.1 00-50-BA-DA-02-51 Dynamic
System 10.47.65.25 00-50-BA-DA-03-2B Dynamic
System 10.50.8.7 00-E0-18-45-C7-28 Dynamic
System 10.90.90.90 00-01-02-03-04-00 Local
System 10.255.255.255 FF-FF-FF-FF-FF-FF Local/Broadcast
Total Entries = 20
DGS-3400:4#
show arpentry ipv6
Used to display the ARP table.
show arpentry ipv6 {<ipv6addr>}
Description This command is used to display the current contents of the Switch’s ARP table.
Parameters
<ipv6addr> − The network IPv6 address corresponding to the IP interface name
above.
Restrictions None.
Purpose
Syntax
Example usage:
To display the ARP table:
DGS-3400:4#show arpentry ipv6
Total Entries = 2
Command: show arpentry ipv6
Interface IPV6 Address MAC Address Type
------------- --------------- ----------------- ---------------
System 2D30::AC21 FF-FF-FF-FF-FF-FF Local/Broadcast
System 2B30::AC20 00-50-BA-70-E4-4E Dynamic
DGS-3400:4#
180