D-Link xStack DGS-3450 - Page 199

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config authen_login
Parameters
Parameters
 xtacacs – Adding this parameter will require the user to be authenticated using the
XTACACS protocol from the remote XTACACS server hosts of the XTACACS
server group list.
 server_group <string 15> - Adding this parameter will require the user to be
authenticated using a user-defined server group previously configured on the
Switch.
method_list_name – Enter a previously implemented method list name defined by the user.
The user may add one, or a combination of up to four (4) of the following authentication
methods to this method list:
server_group <string 15> - Adding this parameter will require the user to be
authenticated using a user-defined server group previously configured on the
h.
default – The default method list for access authentication, as defined by the user. The user
may choose one or a combination of up to four(4) of the following authentication methods:

Switc
NOTE: Entering none or local as an authentication protocol will override any other
authentication that follows it on a method list or on the default method list.
Restrictions Only administrator-level users can issue this command.
 tacacs – Adding this parameter will require the user to be authenticated using the
TACACS protocol from the remote TACACS server hosts of the TACACS server
group list.
 tacacs+ – Adding this parameter will require the user to be authenticated using the
TACACS+ protocol from the remote TACACS+ server hosts of the TACACS+
server group list.
 radius - Adding this parameter will require the user to be authenticated using the
RADIUS protocol from the remote RADIUS server hosts of the RADIUS server
group list.
 local - Adding this parameter will require the user to be authenticated using the
local user account database on the Switch.
 none – Adding this parameter will require no authentication to access the sSwitch.
 tacacs – Adding this parameter will require the user to be authenticated using the
TACACS protocol from a remote TACACS server.
 xtacacs – Adding this parameter will require the user to be authenticated using the
XTACACS protocol from a remote XTACACS server.
 tacacs+ – Adding this parameter will require the user to be authenticated using the
TACACS+ protocol from a remote TACACS+ server.
 radius - Adding this parameter will require the user to be authenticated using the
RADIUS protocol from a remote RADIUS server.
 local - Adding this parameter will require the user to be authenticated using the
local user account database on the Switch.
 none – Adding this parameter will require no authentication to access the Switch.
Example usage:
To configure the user defined method list “Trinity” with authentication methods tacacs, xtacacs and local, in that order.
DGS-3400:4#config authen_login method_list_name Trinity method tacacs xtacacs local
Success.
Command: config authen_login method_list_name Trinity method tacacs xtacacs local
DGS-3400:4#
Example usage:
To configure the default method list with authentication methods xtacacs, tacacs+ and local, in that order:
196