xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show authen_enable
all – Entering this parameter will display all the authentication login
methods currently configured on the Switch.
The window will display the following parameters:
Restrictions
Method List Name – The name of a previously configured
method list name.
Comment – Defines the type of Method. User-defined Group
refers to server groups defined by the user. Built-in Group
refers to the TACACS, XTACACS, TACACS+ and RADIUS
security protocols which are permanently set in the Switch.
Keyword refers to authentication using a technique INSTEAD
of TACACS/XTACACS/TACACS+/RADIUS which are local
(authentication through the local_enable password on the
Switch) and none (no authentication necessary to access any
function on the Switch).
Priority – Defines which order the method list protocols will be
queried for authentication when a user attempts to log on to
the Switch. Priority ranges from 1(highest) to 4 (lowest).
Method Name – Defines which security protocols are
implemeted, per method list name.
None
Example usage:
To display all method lists for promoting user level privileges to administrator level privileges.
DGS-3400:4#show authen_enable all
Command: show authen_enable all
Method List Name Priority Method Name Comment
---------------- -------- --------------- ------------------
Permit 1 tacacs+ Built-in Group
2 tacacs Built-in Group
3 Darren User-defined Group
4 local Keyword
default 1 tacacs+ Built-in Group
2 local Keyword
Total Entries : 2
DGS-3400:4#
config authen application
Used to configure various applications on the Switch for authentication
using a previously configured method list.
config authen application [console | telnet | ssh | http | all] [login |
enable] [default | method_list_name <string 15>]
Description This command is used to configure Switch configuration applications
(console, telnet, ssh, web) for login at the user level and at the
administration level (authen_enable) utilizing a previously configured
method list.
Parameters application – Choose the application to configure. The user may choose one
of the following five options to configure.
Purpose
Syntax
console – Choose this parameter to configure the command line
interface login method.
telnet – Choose this parameter to configure the telnet login
201
To Next Page
Loading...
