xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Example usage:
To view authenticaion server hosts currently set on the Switch:
DGS-3400:4#show authen server_host
Command: show authen server_host
IP Address Protocol Port Timeout Retransmit Key
--------------- -------- ----- ------- --------------- ------------------
10.53.13.94 TACACS 49 5 2 ---------
Total Entries : 1
DGS-3400:4#
create authen server_group
Used to create a user-defined authentication server group.
create authen server_group <string 15>
Description This command will create an authentication server group. A server
group is a technique used to group
TACACS/XTACACS/TACACS+/RADIUS server hosts into user
defined categories for authentication using method lists. The user
may add up to eight (8) authentication server hosts to this group
using the config authen server_group command.
Parameters <string 15> - Enter an alphanumeric string of up to 15 characters to
define the newly created server group.
Restrictions Only administrator-level users can issue this command.
Purpose
Syntax
Example usage:
To create the server group “group_1”:
DGS-3400:4#create authen server_group group_1
Command: create authen server_group group_1
Success.
DGS-3400:4#
config authen server_group
Purpose Used to configure a user-defined authentication server group.
Syntax
config authen server_group [tacacs | xtacacs | tacacs+ | radius |
<string 15>] [add | delete] server_host <ipaddr> protocol [tacacs |
xtacacs | tacacs+ | radius]
Description This command will configure an authentication server group. A server
group is a technique used to group
TACACS/XTACACS/TACACS+/RADIUS server hosts into user defined
categories for authentication using method lists. The user may define the
type of server group by protocol or by previously defined server group. Up
to eight (8) authentication server hosts may be added to any particular
group
Parameters server_group - The user may define the group by protocol groups built into
the Switch (TACACS/XTACACS/TACACS+/RADIUS), or by a user-defined
group previously created using the create authen server_group command.
tacacs – Use this parameter to utilize the built-in TACACS server
protocol on the Switch. Only server hosts utilizing the TACACS
206
To Next Page
Loading...
