EasyManua.ls Logo

D-Link xStack DGS-3450 - Page 211

D-Link xStack DGS-3450
247 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#delete server_group group_1
Command: delete server_group group_1
Success.
DGS-3400:4#
show authen server_group
Purpose Used to view authentication server groups on the Switch.
Syntax
show authen server_group <string 15>
Description This command will display authentication server groups currently
configured on the Switch.
This command will display the following fields:
Group Name: The name of the server group currently configured on
the Switch, including built in groups and user defined groups.
IP Address: The IP address of the server host.
Protocol: The authentication protocol used by the server host.
Parameters <string 15> - Enter an alphanumeric string of up to 15 characters to
define the previously created server group to be viewed.
Entering this command without the <string> parameter will display all
authentication server groups on the Switch.
Restrictions None.
Example usage:
To view authentication server groups currently set on the Switch.
DGS-3400:4#show authen server_group
Command: show authen server_group
Group Name IP Address Protocol
--------------- --------------- --------
Darren 10.53.13.2 TACACS
tacacs 10.53.13.94 TACACS
tacacs+ (This group has no entry)
------------ (This group has no entry)
Total Entries : 4
DGS-3400:4#
config authen parameter response_timeout
Purpose Used to configure the amount of time the Switch will wait for a user to enter
authentication before timing out.
Syntax
config authen parameter response_timeout <int 0-255>
Description This command will set the time the Switch will wait for a response of
authentication from the user.
Parameters response_timeout <int 0-255> - Set the time, in seconds, the Switch will wait
for a response of authentication from the user attempting to log in from the
command line interface or telnet interface. “0” (integer zero) means there
won’t be a time-out. The default value is 30 seconds.
Restrictions Only administrator-level users can issue this command.
Example usage:
208

Other manuals for D-Link xStack DGS-3450

Related product manuals