D-Link xStack DGS-3450 - Page 220

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config ssh algorithm
Parameters 3DES – This parameter will enable or disable the Triple_Data
Encryption Standard encryption algorithm.
[enable | disable] – This allows you to enable or disable algorithms
entered in this command, on the Switch.
AES128 - This parameter will enable or disable the Advanced
Encryption Standard AES128 encryption algorithm.
AES192 - This parameter will enable or disable the Advanced
Encryption Standard AES192 encryption algorithm.
AES256 - This parameter will enable or disable the Advanced
Encryption Standard AES256 encryption algorithm.
arcfour - This parameter will enable or disable the Arcfour encryption
algorithm.
blowfish - This parameter will enable or disable the Blowfish encryption
algorithm.
cast128 - This parameter will enable or disable the Cast128 encryption
algorithm.
twofish128 - This parameter will enable or disable the twofish128
encryption algorithm.
twofish192 - This parameter will enable or disable the twofish192
encryption algorithm.
MD5 - This parameter will enable or disable the MD5 Message Digest
encryption algorithm.
SHA1 - This parameter will enable or disable the Secure Hash
Algorithm encryption.
RSA - This parameter will enable or disable the RSA encryption
algorithm.
DSA - This parameter will enable or disable the Digital Signature
Algorithm encryption.
Restrictions Only administrator-level users can issue this command.
Usage example:
To configure SSH algorithm:
DGS-3400:4# config ssh algorithm Blowfish enable
Command: config ssh algorithm Blowfish enable
Success.
DGS-3400:4#
show ssh algorithm
Purpose Used to display the SSH algorithm setting.
Syntax
show ssh algorithm
Description This command will display the current SSH algorithm setting status.
Parameters None.
Restrictions None.
Usage Example:
To display SSH algorithms cuurently set on the Switch:
217