xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
enable ssl
Purpose To enable the SSL function on the Switch.
Syntax
enable ssl {ciphersuite {RSA_with_RC4_128_MD5 |
RSA_with_3DES_EDE_CBC_SHA |
DHE_DSS_with_3DES_EDE_CBC_SHA |
RSA_EXPORT_with_RC4_40_MD5}}
Description This command will enable SSL on the Switch by implementing any one or
combination of listed ciphersuites on the Switch. Entering this command
without a parameter will enable the SSL status on the Switch. Enabling
SSL will disable the web-manager on the Switch.
Parameters ciphersuite - A security string that determines the exact cryptographic
parameters, specific encryption algorithms and key sizes to be used for an
authentication session. The user may choose any combination of the
following:
The ciphersuites are enabled by default on the Switch, yet the SSL status
is disabled by default. Enabling SSL with a cipersuite will not enable the
SSL status on the Switch.
Restrictions Only administrator-level users can issue this command.
• RSA_with_RC4_128_MD5 – This ciphersuite combines the RSA
key exchange, stream cipher RC4 encryption with 128-bit keys
and the MD5 Hash Algorithm.
• RSA_with_3DES_EDE_CBC_SHA - This ciphersuite combines
the RSA key exchange, CBC Block Cipher 3DES_EDE encryption
and the SHA Hash Algorithm.
• DHE_DSS_with_3DES_EDE_CBC_SHA - This ciphersuite
combines the DSA Diffie Hellman key exchange, CBC Block
Cipher 3DES_EDE encryption and SHA Hash Algorithm.
• RSA_EXPORT_with_RC4_40_MD5 - This ciphersuite combines
the RSA Export key exchange, stream cipher RC4 encryption with
40-bit keys.
Example usage:
To enable SSL on the Switch for all ciphersuites:
DGS-3400:4#enable ssl
Command:enable ssl
Note: Web will be disabled if SSL is enabled.
Success.
DGS-3400:4#
NOTE: Enabling SSL on the Switch will enable all ciphersuites. To utilize a particular
ciphersuite, the user must eliminate other ciphersuites by using the disable ssl
command along with the appropriate ciphersuites.
NOTE: Enabling the SSL function on the Switch will disable the port for the web
manager (port 80). To log on to the web based manager, the entry of your URL must
begin with https://. (ex. https://10.90.90.90)
220
To Next Page
Loading...
Need help?
General