xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
create snmp user
md5 − Specifies that the HMAC-MD5-96 authentication level will be used. md5
may be utilized by entering one of the following:
• <auth password 8-16> - An alphanumeric sting of between 8 and 16
characters that will be used to authorize the agent to receive packets for
the host.
• <auth_key 32-32> - Enter an alphanumeric sting of exactly 32
characters, in hex form, to define the key that will be used to authorize
the agent to receive packets for the host.
sha − Specifies that the HMAC-SHA-96 authentication level will be used.
• <auth password 8-20> - An alphanumeric sting of between 8 and 20
characters that will be used to authorize the agent to receive packets for
the host.
• <auth_key 40-40> - Enter an alphanumeric sting of exactly 40
characters, in hex form, to define the key that will be used to authorize
the agent to receive packets for.
priv – Adding the priv (privacy) parameter will allow for encryption in addition to
the authentication algorithm for higher security. The user may choose:
• des – Adding this parameter will allow for a 56-bit encryption to be
added using the DES-56 standard using:
<priv_password 8-16> - An alphanumeric string of between 8 and 16
characters that will be used to encrypt the contents of messages
the host sends to the agent.
<priv_key 32-32> - Enter an alphanumeric key string of exactly 32
characters, in hex form, that will be used to encrypt the contents
of messages the host sends to the agent.
• none – Adding this parameter will add no encryption.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To create an SNMP user on the Switch:
DGS-3400:4#create snmp user dlink default encrypted by_password auth md5
canadian priv none
Command: create snmp user dlink default encrypted by_password auth md5
canadian priv none
Success.
DGS-3400:4#
delete snmp user
Purpose
Used to remove an SNMP user from an SNMP group and also to
delete the associated SNMP group.
Syntax delete snmp user <username 32>
Description
The delete snmp user command removes an SNMP user from its
SNMP group and then deletes the associated SNMP group.
Parameters
<username 32> − An alphanumeric string of up to 32 characters that
identifies the SNMP user that will be deleted.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To delete a previously entered SNMP user on the Switch:
29
To Next Page
Loading...
Need help?
General