xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#show snmp view
Command: show snmp view
Vacm View Table Settings
View Name Subtree View Type
-------------------- ------------------------- ----------
ReadView 1 Included
WriteView 1 Included
NotifyView 1.3.6 Included
restricted 1.3.6.1.2.1.1 Included
restricted 1.3.6.1.2.1.11 Included
restricted 1.3.6.1.6.3.10.2.1 Included
restricted 1.3.6.1.6.3.11.2.1 Included
restricted 1.3.6.1.6.3.15.1.1 Included
CommunityView 1 Included
CommunityView 1.3.6.1.6.3 Excluded
CommunityView 1.3.6.1.6.3.1 Included
Total Entries: 11
DGS-3400:4#
create snmp community
Purpose Used to create an SNMP community string to define the relationship between
the SNMP manager and an agent. The community string acts like a password to
permit access to the agent on the Switch. One or more of the following
characteristics can be associated with the community string:
An Access List of IP addresses of SNMP managers that are permitted to use the
community string to gain access to the Switch’s SNMP agent.
An MIB view that defines the subset of all MIB objects that will be accessible to
the SNMP community.
read_write or read_only level permission for the MIB objects accessible to the
SNMP community.
Syntax
create snmp community <community_string 32> view <view_name 32>
[read_only | read_write]
Description
The create snmp community command is used to create an SNMP community
string and to assign access-limiting characteristics to this community string.
Parameters
<community_string 32> − An alphanumeric string of up to 32 characters that is
used to identify members of an SNMP community. This string is used like a
password to give remote SNMP managers access to MIB objects in the Switch’s
SNMP agent.
<view_name 32> − An alphanumeric string of up to 32 characters that is used to
identify the group of MIB objects that a remote SNMP manager is allowed to
access on the Switch.
read_only − Specifies that SNMP community members using the community
string created with this command can only read the contents of the MIBs on the
Switch.
read_write − Specifies that SNMP community members using the community
string created with this command can read from and write to the contents of the
MIBs on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create the SNMP community string “dlink:”
32
To Next Page
Loading...
Need help?
General