xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#enable snmp authenticate traps
Command: enable snmp authenticate traps
Success.
DGS-3400:4#
show snmp traps
Purpose Used to show SNMP trap support on the Switch .
Syntax
show snmp traps
Description This command is used to view the SNMP trap support status
currently configured on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To view the current SNMP trap support:
DGS-3400:4#show snmp traps
Command: show snmp traps
SNMP Traps : Enabled
Authenticate Traps : Enabled
DGS-3400:4#
disable snmp traps
Purpose Used to disable SNMP trap support on the Switch.
Syntax
disable snmp traps
Description This command is used to disable SNMP trap support on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To prevent SNMP traps from being sent from the Switch:
DGS-3400:4#disable snmp traps
Command: disable snmp traps
Success.
DGS-3400:4#
42
To Next Page
Loading...
