xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400 Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.20-B15
Copyright(C) 2004-2007 D-Link Corporation. All rights reserved.
DGS-3400:4#
DGS-3400:4#
DGS-3400:4#download config 10.41.44.44 c:\cfg\setting.txt
Command: download config 10.41.44.44 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
The very end of the autoconfig process including the logout appears like this:
DGS-3400:4# create iproute default 172.18.212.253 1
Command: create iproute default 172.18.212.253 1
Success.
DGS-3400:4#
DGS-3400:4##-------------------------------------------------------------------
DGS-3400:4## End of configuration file for DGS-3400
DGS-3400:4#
**********
* Logout *
**********
NOTE: With autoconfig enabled, the Switch ipif settings now define the Switch as a
DHCP client. Use the show switch command to display the new IP settings status.
disable autoconfig
Purpose Use this to deactivate autoconfiguration from DHCP.
Syntax
disable autoconfig
Description This instructs the Switch not to accept autoconfiguration instruction from the
DHCP server. This does not change the IP settings of the Switch. The ipif
settings will continue as DHCP client until changed with the config ipif
command.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To stop the autoconfiguration function:
DGS-3400:4#disable autoconfig
Command: disable autoconfig
Success.
DGS-3400:4#
52
To Next Page
Loading...
