xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#show packet port 2
Command: show packet port 2
Port number :2
================================================================
Frame Size/Type Frame Counts Frames/sec
--------------- ---------------------- -----------
64 3275 10
65-127 755 10
128-255 316 1
256-511 145 0
512-1023 15 0
1024-1518 0 0
Unicast RX 152 1
Multicast RX 557 2
Broadcast RX 3686 16
Frame Type Total Total/sec
--------------- ---------------------- -----------
RX Bytes 408973 1657
RX Frames 395 19
TX Bytes 7918 178
TX Frames 111 2
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
show error ports
Purpose Used to display the error statistics for a range of ports.
Syntax
show
error ports <portlist>
Description This command will display all of the packet error statistics collected
and logged by the Switch for a given port list.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
Restrictions None.
Example usage:
To display the errors of the port 3 of module 1:
DGS-3400:4#show error ports 3
Command: show error ports 3
Port number : 1
RX Frames TX Frames
--------------- ----------------
CRC Error 19 Excessive Deferral 0
Undersize 0 CRC Error 0
Oversize 0 Late Collision 0
Fragment 0 Excessive Collision 0
Jabber 11 Single Collision 0
Drop Pkts 20837 Collision 0
Symbol Error 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
55
To Next Page
Loading...
