xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config syslog host all
22 local use 6 (local6)
23 local use 7 (local7)
local0 − Specifies that local use 0 messages will be sent to the remote
host. This corresponds to number 16 from the list above.
local1 − Specifies that local use 1 messages will be sent to the remote
host. This corresponds to number 17 from the list above.
local2 − Specifies that local use 2 messages will be sent to the remote
host. This corresponds to number 18 from the list above.
local3 − Specifies that local use 3 messages will be sent to the remote
host. This corresponds to number 19 from the list above.
local4 − Specifies that local use 4 messages will be sent to the remote
host. This corresponds to number 20 from the list above.
local5 − Specifies that local use 5 messages will be sent to the remote
host. This corresponds to number 21 from the list above.
local6 − Specifies that local use 6 messages will be sent to the remote
host. This corresponds to number 22 from the list above.
local7 − Specifies that local use 7 messages will be sent to the remote
host. This corresponds to number 23 from the list above.
udp_port <udp_port_number> − Specifies the UDP port number that the
syslog protocol will use to send messages to the remote host.
state [enable | disable] − Allows the sending of syslog messages to the
remote host, specified above, to be enabled and disabled.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure all syslog hosts:
DGS-3400:4#config syslog host all severity all
Command: config syslog host all severity all
Success.
DGS-3400:4#config syslog host all facility local0
Command: config syslog host all facility local0
Success
DGS-3400:4#config syslog host all udp_port 6000
Command: config syslog host all udp_port 6000
Success.
DGS-3400:4#config syslog host all ipaddress 10.44.67.8
Command: config syslog host all ipaddress 10.44.67.8
Success.
DGS-3400:4#config syslog host all state enabled
Command: config syslog host all state enabled
Success.
DGS-3400:4#
64
To Next Page
Loading...
