xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show stp instance_id
Purpose Used to display the Switch’s STP instance configuration
Syntax
show stp instance_id <value 0-15>
Description This command displays the Switch’s current STP Instance
Settings and the STP Instance Operational Status.
Parameters <value 0-15> - Enter a value defining the previously configured
instance_id on the Switch. An entry of 0 will display the STP
configuration for the CIST internally set on the Switch.
Restrictions None.
Example usage:
To display the STP instance configuration for instance 0 (the internal CIST) on the Switch:
DGS-3400:4#show stp instance 0
Command: show stp instance 0
STP Instance Settings
---------------------------
Instance Type : CIST
Instance Status : Enabled
Instance Priority : 32768(bridge priority : 32768, sys ID ext : 0 )
STP Instance Operational Status
--------------------------------
Designated Root Bridge : 32766/00-90-27-39-78-E2
External Root Cost : 200012
Regional Root Bridge : 32768/00-53-13-1A-33-24
Internal Root Cost : 0
Designated Bridge : 32768/00-50-BA-71-20-D6
Root Port : 1
Max Age : 20
Forward Delay : 15
Last Topology Change : 856
Topology Changes Count : 2987
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
show stp mst_config_id
Purpose Used to display the MSTP configuration identification.
Syntax
show stp mst_config_id
Description This command displays the Switch’s current MSTP configuration
identification.
Parameters None.
Restrictions None.
Example usage:
To show the MSTP configuration identification currently set on the Switch:
79
To Next Page
Loading...
