xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config multicast filtering_mode
Purpose Used to configure the multicast packet filtering mode for specific VLANs .
Syntax
config multicast filtering_mode [<vlan_name 32> | all]
[forward_all_groups | forward_unregistered_groups |
filter_unregistered_groups]
Description This command will configure the multicast packet filtering mode for specified
VLANs on the Switch.
Parameters <vlan_name 32> - Specifies a VLAN by VLAN name to set. If no VLAN is
defined here, the rule is applied to all VLANs
[forward_all_groups | forward_unregistered_groups |
filter_unregistered_groups] – The user may set the filtering mode to any of
these three options.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the multicast filtering mode to forward all groups on all VLANs.
DGS-3400:4#config multicast filtering_mode all filter_unregistered_groups
Command: config multicast filtering_mode all filter_unregistered_groups
Success.
DGS-3400:4#
show multicast filtering_mode
Purpose Used to show the multicast packet filtering mode as configured for
the VLANs.
Syntax
show multicast filtering_mode {vlan <vlan_name 32>}
Description This command will display the current multicast packet filtering
mode for specified VLANs or all VLANs on the Switch.
Parameters vlan <vlan_name 32> - Specifies a VLAN to to display multicast
filtering status.
Restrictions None.
Example usage:
To view the multicast filtering mode for all VLANs:
DGS-3400:4#show multicast filtering_mode
Command: show multicast filtering_mode
VLAN Name Multicast Filter Mode
-------------------------------- -----------------------------
default filter_unregistered_groups
v1 filter_unregistered_groups
v2 filter_unregistered_groups
v3 filter_unregistered_groups
DGS-3400:4#
86
To Next Page
Loading...
