D-Link xStack DGS-3450 - Page 93

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show traffic control
Purpose Used to display current traffic control settings.
Syntax
show traffic control {<portlist>}
Description This command displays the current storm traffic control configuration on
the Switch.
Parameters <portlist> - Specify a range of ports to display. If unspecified, all ports will
be displayed.
Restrictions None.
Example usage:
To display traffic control setting:
DGS-3400:4#show traffic control
Command: show traffic control
Traffic Storm Control Trap :[None]
Port Thres Broadcast Multicast DLF Action Count Time Shutdown
hold Storm Storm Storm down Interval Forever
---- ----- --------- --------- -------- -------- ----- -------- --------
1 1000 Enabled Disabled Disabled drop 0 5
2 1000 Enabled Disabled Disabled drop 0 5
3 1000 Enabled Disabled Disabled drop 0 5
4 1024 Disabled Disabled Disabled drop 0 5
5 1024 Disabled Disabled Disabled drop 0 5
6 1024 Disabled Disabled Disabled drop 0 5
7 1024 Disabled Disabled Disabled drop 0 5
8 1024 Disabled Disabled Disabled drop 0 5
9 1024 Disabled Disabled Disabled drop 0 5
10 1024 Disabled Disabled Disabled drop 0 5
11 1024 Disabled Disabled Disabled drop 0 5
12 1024 Disabled Disabled Disabled drop 0 5
13 1024 Disabled Disabled Disabled drop 0 5
14 1024 Disabled Disabled Disabled drop 0 5
15 1024 Disabled Disabled Disabled drop 0 5
16 1024 Disabled Disabled Disabled drop 0 5
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
90