xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config bandwidth_control
Purpose Used to configure bandwidth control on a port by-port basis.
Syntax
<portlist> {rx_rate [no_limit | <value 1-156249>] | tx_rate
[no_limit | <value 1-156249>]}
Description The config bandwidth_control command is used to configure
bandwidth on a port by-port basis.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
rx_rate − Specifies that one of the parameters below (no_limit or
<value 1-156249>) will be applied to the rate at which the above
specified ports will be allowed to receive packets
no_limit − Specifies that there will be no limit on the rate of
packets received by the above specified ports.
<value 1-156249> − Specifies the packet limit, in Kbps, that
the above ports will be allowed to receive.
tx_rate − Specifies that one of the parameters below (no_limit or
<value 1-156249>) will be applied to the rate at which the above
specified ports will be allowed to transmit packets.
no_limit − Specifies that there will be no limit on the rate of
packets received by the above specified ports.
<value 1-156249> − Specifies the packet limit, in Kbps, that
the above ports will be allowed to receive.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure bandwidth control:
DGS-3400:4#config bandwidth_control 1-8 rx_rate 64 tx_rate 64
Command: config bandwidth_control 1-8 rx_rate 64 tx_rate 64
Success.
DGS-3400:4#
show bandwidth_control
Purpose Used to display the bandwidth control table.
Syntax
show
bandw
idth_control {<portlist>}
Description The show bandwidth_control command displays the current
bandwidth control configuration on the Switch, on a port-by-port
basis.
Parameters
<portlist> − Specifies a port or range of ports to be viewed.
Restrictions None.
Example usage:
To display bandwidth control settings:
92
To Next Page
Loading...
