D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
1
Printed in Jan. 2001 PS-MMA0415-E1A
1. GENERAL INFORMATION
1.1. General Repair Instructions
1. Before performing service operation, disconnect the grounding cable from the battery
for reducing the chance of cable damage and burning due to short-circuiting.
2. Use covers for preventing the components from damage or pollution.
3. Engine oil and anti-freeze solution must be handled with reasonable care as they
cause paint damage.
4. The use of proper tools and special tools where specified is important to efficient and
reliable service operation.
5. Use genuine DAEWOO parts necessarily.
6. Used cotter pins, gaskets, O-rings, oil seals, lock washer and self-lock nuts should
be discarded and new ones should be prepared for installation as normal function of
the parts can not be maintained if these parts are reused.
7. To facilitate proper and smooth reassemble operation, keep disassembled parts
neatly in groups. Keeping fixing bolts and nut separate is very important as they vary
in hardness and design depending on position of installation.
8. Clean the parts before inspection or reassembly. Also clean oil ports, etc. using
compressed air to make certain they are free from restrictions.
9. Lubricate rotating and sliding faces of parts with oil or grease before installation.
10. When necessary, use a sealer on gaskets to prevent leakage.
11. Carefully observe all specifications for bolts and nuts torques.
12. When service operation is completed, make a final check to be sure service has
been done property.
To Next Page
Loading...
Need help?
General
