Daewoo D1146 - Fuel Injection Nozzle

D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
38
Printed in Jan. 2001 PS-MMA0415-E1A
3.1.20. Fuel injection nozzle
z Unscrew the fuel injection pipe between
the injection pump and nozzle and take
off the pipe.
z Install a special jig on the nozzle holder,
and then pull out the nozzle as striking
the hammer of the jig backwardly.
Take care not to damage the nozzle
at disassembly.
z Take out the seal ring from the nozzle
hole of the cylinder head and discard it.
3.1.21. Turbo charger (D1146TI, DE08TIS)
z Remove the oil supply pipe and oil return
pipe between the turbo charger and the
cylinder block.
z Unclamp the rubber hose connected the
intercooler and air cleaner.
z Unscrew the turbo charger fixing nuts and
take off the turbo charger from the
exahust manifold.
3.1.22. Exhaust manifold
z Unscrew the exhaust manifold fixing nuts
and remove the heat shield from the
exhaust manifold.
z Then disassemble the exhaust manifold
and gasket.
z Scrap the used gasket.