D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
46
Printed in Jan. 2001 PS-MMA0415-E1A
3.1.41. Crankshaft
z Assemble the bolts on the both side of
crankshaft temporarily.
z Connect the rope to the bolts and lift the
crankshaft by means of crane being
careful not to give any damage on it.
z In order for the disassembled crankshaft
to be prevented from bends or damage,
put it on the special lathe and store.
z Disassemble the metal bearings in turn
and store them.
NOTES :
Do not mingle with the metal bearings
and bearing caps randomly. To prevent
mixing, temporarily assemble the metal
bearings to the corresponding bearing
caps in turn.
3.1.42. Camshaft and tappet
z In order for camshaft not to be damaged,
disassemble turning it.
z In order for the disassembled camshaft to
be prevented from bends or damage, put
it on the special lathe and store.
z Pull out the tappet.
z As required, pull out the camshaft bush
from the cylinder block by a press.
z Check for damage, scratch, wearing state
and if abnormal, tear down.
To Next Page
Loading...
