- 19 -
Removal
<Remover and Installer : Filter Wrench>
1) After release the drain plug, and remove the
oil if upper system.
2) Draw out filter as turning it counterclock
wise.
3) Do not reuse the drew out filter.
Assembly
1) Wipe the oil filter mounting face with a clean
rag to install the new filter.
2) Lightly oil at the O-ring part.
3) Turn in the new oil filter until the sealing face
is fitted against the O-ring.
4) Additionally tighten 3/4 of a turn with a
wrench.
5) Check the engine oil level and replenish to
the specified level if necessary.
6) Check the leakage at the replaced filter as
operating the engine.
EJM1018I
EJM1019I
Set the Filter
Wrench
Cartridge
Drain Plug
<Upword type>
<Downword type>
1.5. Maintenance
1.5.1. Replacement of Oil Filter
Cartridge (Spin-On) Type
<Removal>
1) Turn in the filter toward counterclock wise
with a wrench or manual, and discard it.
2) Wipe the oil filter mounting face with a clean
rag to install the new filter.
EJM1021S
1.5.2. Replacement of Fuel Filter
To Next Page
Loading...