Daewoo DB58 - Page 24

- 21 -
• Inspection procedure
1) Fix the injection nozzle in a vise.
2) Release nozzle holder cap with a wrench.
3) Disassemble the injection nozzle holder from
a vise.

Adjusting Procedure
Check of Injection Starting Pressure
1) Assemble nozzle holder at nozzle tester.
2) Release adjustment screw (1), As shown in
fig.
3) Check injection pressure and injection
statement.
4) Adjust injection nozzle starting pressure if
necessary.
Adjust injection nozzle starting pressure as
set starting a handle of nozzle tester.

CAUTION

The marked (*) can be
changed according to the
loaded vehicles.
Feel free contact to this
firm when you have a
quantion in this manual.

CAUTION

Carefully keep away from
skin and keep off from
tester because pressure of
nozzle tester is very high
when inject.
EJM1023S
EIO3008S
EJM1024S
EJM1025S
EJM1026S
1.5.3. Injection Nozzle
DB58 DB58T DB58TI
Injection Starting Pressure 181 kg/cm
2
185 kg/cm
2
185 kg/cm
2


