G424 Service Manual Gasoline Fuel System70
6EN0869
6EN0856
6EN0858
(2) Main jets have size symbols stamped on their ends for
identification.
Size symbols : 132.5
B Check ball/weight installation
Install the acceleration check ball and weight.
C Float/float pin installation
After the float and float pin have been installed, make sure
that the float is in a level position.
• Strangler spring setting positions
If the strangler spring of the choke valve shaft is out of
position, set it correctly in the positions shown in the
illustration.
Size symbol
Weight
Check ball
Hole A
Spring
Setting
Positions
Hole B
Hole C
3rd Stage
2nd stage
1st stage
132.5
To Next Page
Loading...
Need help?
General
