022-00028AE Operation and Maintenance Manual Operation 3-3
4. Set pilot cutoff switch to "O" (LOCK)
position. This will "LOCK" pilot control
valve lever (joystick).
5. Rotate starter key to "I" (ON) position. All
indicator lights should turn "ON."
NOTE:
If unit is equipped with and
emergency steering system.
Test system before starting
engine. If system does not
function properly, do not start
unit. Follow test procedure
given with test switch.
6. Rotate starter key to "START" position.
Starter motor should crank immediately,
and engine should start within a few
seconds.
7. Release starter key when engine starts.
Key will return to "I" (ON) position.
8. After engine starts, check all indicator
lights and gauges to be certain that all
IMPORTANT
If engine does not start after
approximately 15 seconds of
cranking, release Starter Key. Wait 5
minutes for starter motor to cool
down. Repeat step 6.
HBOI111L
O
I
Figure 4
HAOB320L
Figure 5
HAOB350L
Figure 6
HAOB360L
Figure 7
To Next Page
Loading...
