Dahua Lite NVR2104-4KS2 User Manual

261
Step 5 Click Apply button to complete setup.
Note
After set the heat map parameters, go to main menu->Info->Event->Heat map to view heat map
report. Refer to chapter 4.10.2.3.3 for detailed setup information.
4.7.7 Plate Recognition
4.7.7.1 Plate recognition settings
Device can generate an alarm when it detects the corresponding plate information.
Please follow the steps listed below.
Step 1 From main menu->Setting->Event->Plate recognition->Plate recognition.
Enter plate recognition interface. See Figure 4-144.
Figure 4-144
Step 2 Check Enable to enable plate recognition function.
Step 3 Select a channel number and then click the Rule to set the plate recognition name and detection
zone.
Step 4 Click Regular, blacklist, whitelist to set.
Note
Before use blacklist alarm or whitelist alarm function, please add the corresponding plate
information. Refer to chapter 4.7.7.2 B/W list for detailed information.
 Regular: In this interface, device triggers an alarm when it detects all plate numbers.
 Blacklist: In this interface, device triggers an alarm when it detects plate number in the
blacklist.

Dahua Lite NVR2104-4KS2 Specifications

General

Brand	Dahua
Model	Lite NVR2104-4KS2
Category	Network Hardware
Language	English