Dahua VEC0404HD-M70 - Page 108

103
Figure 4- 31
Please see Figure 4- 31.
 Network mode: There are three modes of multiple, fault-tolerant and load balancing.
 Aggregation: Under net bridge mode only.
 Net Bridge: Under net bridge mode only.
 Bridge cycle set: Under net bridge mode only.
 Ethernet: Network card 1~8 available.
 Default network card: Network card 1~8 available.
 Aggregation strategy: Under link aggregation under.
 IP Version: IPv4 and IPv6.
 IP address: Input corresponding IP address, and then set its subnet mask and gateway.
 DHCP: It is to auto search IP. When enable DHCP function, you cannot modify IP/Subnet
mask /Gateway. These values are from DHCP function. If you have not enabled DHCP
function, IP/Subnet mask/Gateway display as zero. You need to disable DHCP function to
view current IP information. Besides, when PPPoE is operating, you cannot modify
IP/Subnet mask /Gateway.
 Device name: You can customize device name.
 TCP port: Default value is 37777. You can change if necessary.
 HTTP port: Default value is 80.
 PRSP port: Default value is 554.
 UDP port: Default value is 37778.