48
Figure 3- 38
Function: There are various devices for you to select. Console is for you to use the COM or
mini-end software to upgrade or debug the program. The keyboard is for you to control the
device via the special keyboard. Adapter is to connect to the PC to transfer data directly.
Net keyboard is for you to use the special keyboard to control the device. MatrixCom is to
connect to the peripheral matrix control. PELCO is for you to control matrix via PELCO.
Baud rate: You can select proper baud rate.
Data bit: You can select proper data bit. The value ranges from 5 to 8.
Stop bit: There are two values: 1/2.
Parity: there are four choices: odd/even/space/mark.
System default setting is:
Function: Console
Baud rate:115200
Data bit:8
Stop bit:1
Parity: None.
Address: You can set address.
3.2.4.5 Network
Network interface is shown below as in Figure 3- 39.
To Next Page
Loading...
