49
Figure 3- 39
Network Mode: It includes multi-addresses, fault tolerance, load balance, net bridge and
link aggregation.
Aggregation Set: Under net bridge mode under.
Net bridge Set: Under net bridge mode only. This setup can bind any two network cards
to one net bridge as one network card can only bind one net bridge. Bound net bridge
will be shown in Ethernet dropdown box. Bound network card as net bridge will be not
shown.
Ethernet Card Name: You can select from 1~~2.
Default Ethernet port: You can select from 1~~2. Under multiple addresses and bridge mode
only.
Aggregation strategy: Under aggregation link mode only. Strategies available are MAC-
address-based, IP-address-and-port-based, IP-address-and-MAC-address-based. IP-
address-and-port-based.
IP version: IPv4 and IPv6.
IP address: Here you can input IP address and then set corresponding subnet mask and default
gateway.
DHCP: It is to auto search IP. When enable DHCP function, you cannot modify IP/Subnet
mask /Gateway. These values are from DHCP function. If you have not enabled DHCP
function, IP/Subnet mask/Gateway display as zero. You need to disable DHCP function to
To Next Page
Loading...
