51
Figure 3- 41
3.2.4.5.2 NTP Setting
Figure 3- 42
You need to install SNTP server (Such as Absolute Time Server) in your PC first. In Windows 7
OS, you can use command “net start w32time” to boot up NTP service.
NTP setting interface is shown as in Figure 3- 42.
Host IP: Input your PC address where SNTP server is installed.
Port: This SNTP supports TCP transmission only. Port default value is 123.
Time zone: select your corresponding time zone here.
Here is a sheet for your time zone setting.
To Next Page
Loading...
