Interface Operation 49
Figure 6-12
Input VTH no. in the corresponding forward mode, press to enable the Step 4
forward function. Please refer to Table 6-4 for details.
All incoming calls will be forwarded to preset number immediately.
When the user is busy, incoming call from the third party will be
forwarded to preset number. If “No Answer” is not set, when the user
refuses to answer, the incoming call will be deemed as busy
forwarding.
If no one answers after VTH ring time, the incoming call will be
forwarded to preset number.
Set VTH ring time at “Setting > Ring > Other” interface.
Table 6-4
To forward to an user of another building or unit, the forward number is “Building +
Unit + VTH room number”. For example, input 0101101 for 101 of Unit 1, Building
1.
To forward to an user of the same unit, the forward number is VTH room number.
Press [OK] to save settings. Step 5
6.2.6 General Setting
Set VTH time, display, password and others.
6.2.6.1 Time Setting
Set VTH system time, time zone and DST.
To Next Page
Loading...
