Interface Operation 61
Figure 6-25
Add VTO or fence station. Step 4
Add main VTO.
1) Enter main VTO name, VTO IP, “User Name” and “Password”.
2) Switch the “Enable Status” to be .
“User Name” and “Password” shall be consistent with WEB login user name and
password of VTO. Otherwise, it will fail to connect.
Add sub VTO or fence station.
1) Enter sub VTO/fence station name, IP address, “User Name” and “Password”.
2) Switch the “Enable Status” to be .
Press / to add more sub VTOs/ fence stations.
6.3.5 Default
All parameters of the device, except IP address, can be restored to initial default values.
Press [Setting] for over 6 seconds. Step 1
The system pops up “Password” prompt box.
Enter the password set during initialization, and press [OK]. Step 2
Press [Default]. Step 3
The system displays “Default” interface.
Press [OK]. Step 4
The device reboots and enters initialization interface, representing successful
restoration.
To Next Page
Loading...
