19
2) Enter local IP, Network, and gateway.
3) Tap OK.
The indoor monitor (VTH) configuration is completed.
Configure Main VTO and Sub VTO. There must be only one main VTO and one or
more sub VTOs.
If there are no sub door stations (VTO), then you do not need to do sub door
station (VTO) configurations.
1) Select a door station (VTO).
VTO config (1) Figure 4-17
VTO config (2) Figure 4-18
2) Select Main or Sub.
Enter local IP, Network, gateway; select video standard, date format, time format;
set date and time.
3) Tap OK.
The Networking configuration interface (Figure 4-15) is displayed.
4) Tap One-key Config.
The VTO configuration will be completed in a few seconds.
To Next Page
Loading...
