20
Making the configuration effective Figure 4-19
4.4.1.2 Normal Configuration for VTH (For Apartment)
Tap Apartment on Figure 4-12. Step 1
The Device Init interface is displayed.
Connect the indoor monitor to power source. Step 1
WELCOME is displayed, and then the initialization interface is displayed.
Enter the password, confirm password, and email. Step 2
Password: The password is used when administrators need to go to the project
mode.
Email: The email is used when you need to reset the password.
Tap OK. Step 3
The main menu is displayed.
To Next Page
Loading...
