Configuration 20
select the Enable checkbox to enable the
alternate server.
After you have selected the Alternate Server
Enable checkbox, you can only enter the VTS IP
address, and the VTO will restart.
Click OK to save the configuration. Step 5
The VTO will restart automatically.
When the platform works as SIP server, if it is necessary to set Building No. and
Building Unit No., enable Support Building and Support Unit first.
4.2.5 Adding VTO Devices
You can add VTO devices to the SIP server, and all the VTO devices connected to the same
SIP server can make video call between each other. This section applies to the condition in
which a VTO device works as SIP server, and if you are using other servers as SIP server, see
the corresponding manual for the detailed configuration.
Log in to the web interface of the SIP server, and then select Household Setting > Step 1
VTO No. Management.
The VTO No. Management interface is displayed. See Figure 4-9.
VTO No. management Figure 4-9
Click Add. Step 2
The Add interface is displayed. See Figure 4-10.
To Next Page
Loading...
Need help?
General
